From Livid Wiki

Keypads

Our translucent white silicon rubber keypads designed to be used with our Builder BYOB boards. Each button has a hole on the bottom to allow for LED illumination. The buttons have a conductive backing for creating a contact to a circuit board. The button pad can be easily separated with a razor blade (at your own risk of course) to create a different layout. The pads have holes punched in them that align with Livid product assemblies. For your own purposes you should use a hole ponch to punch out a hole slightly bigger than any mounting screws you may have going through the pads.

These are the same buttons we use on our Ohm64 and block controllers and do not have any printing on them.

Small Pads

Our small pads come in an 4x4 and 8x8 configuration with two medium function buttons on the bottom. The pads can be easily cut with scissors to fit your projects configuration at your own risk.

Specs

4x4 Pad size
3.3125” - width
3.3125” - length
0.75” - height .1875" - radius corners

8x8 Pad size
6.625” - width
7.5” - length
0.75” - height
.1875" - radius corners

Button Size
0.5” - length
0.5” - width
.625” - high

Hole Cutouts
.6125"X.6125"
.2" radius corners
.8175" center to center between holes

8x8 pad dimensions
8x8 pad contacts
Pad contacts library for Eagle
4x4 Small Button Pad Dimensions - Adobe Illustrator

Medium Pads

Our small pads come in an 4x1 configuration with two medium function buttons on the bottom. The pads can be easily cut with scissors to fit your projects configuration (at your own risk).

Specs

Pad Size
1” - width
4” - length
0.75” - height
.125" - radius corners

Button Size
0.625” square

4x1 pad dimensions
4x1 pad contacts
Pad contacts library for Eagle
4x1 Medium Button Pad Dimensions - Adobe Illustrator

Keypads documents by Livid is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 United States License.